Haier Smart Power Series Service Manual page 224

Press this key to execute mode switch. For detailed information, please refer to mode setting.
Note: If using Fresh Air unit, default 3 modes will circulate from cooling→heating→fan→cooling.
Pressing this key, fan speed will be changed in sequence as follows:
(Medium) →
Note: Auto fan will be changed in sequence as follows:
→
There is no auto fan in fan mode; The fan icon will flash when adjusting the fan speed. It will statically display after
the adjustment.
Note: If using Fresh Air unit, fan will be in auto fan and cannot be adjusted. If press FAN key, fan icon and FFFF on
the top-right corner will flash, prompting fan speed cannot be adjusted, and will statically display after 3s. Fresh Air
unit fan speed will be controlled automatically by indoor unit and wired controller will always display auto fan.
Timer ON, Timer OFF, Timer ON/OFF.
Press this key to enter function circulation.
1.Press to select the functions in sequence as follows:
→ → → →
2.Press to select the functions in sequence as follows:
→ → → →
3. Press to confirm function selected. If there is function selected, press
Note: The Left/Right swing
requires cleaning.
Icon
Clock; Parameter setting/inquiry; Malfunction
display; Mode setting.
Timer ON/OFF: Sleeping; Parameter setting/
inquiry; Malfunction display.
ROOM/SET temp. and humidity display, each
step is 0.5°C . For example, if the temp. is
25°C, it will display 25.0°C instead of 25°C.
Humidity display function is reserved.
Energy Saving, This icon will be displayed
only when energy saving function is set.
Filter Cleaning.
Child Lock. This icon will be displayed only
when child lock function is set.
/ Lock/ Central
Motion Sensing (Reserved).
Left/Right Swing. This icon is displayed in
swing mode; no display without swing mode.
Up/Down Swing. This icon is displayed in
swing mode; no display without swing mode.
(High)→Auto →
→
→
→
is valid only after the dip switch is set, the filter icon
(Low)
→
can cancel this function.
222
Smart Power
(Low) →
is shown only after the filter