Installation - Haier Smart Power Series Service Manual

7. Installation

7.1 Before installation <Don't discard any accessories until comp>
• Determine the way to carry unit to installation place.
• Don't remove packing until unit reaches installation place.
• If unpacking is unavoidable, protect unit properly.
7.2 Selection of installation place
(1) Installation place shall meet the following and agreed by customers:
• Place where proper air flow can be ensured.
• No block to air flow.
• Water drainage is smpoth.
• Place strong enough to support unit weight.
• Place where inclination is not evident on ceiling.
• Enough space for mainenance.
• Indoor and outdoor unit piping length is within limit. (Refer to Installation Manual for outdoor unit.)
• Indoor and outdoor unit, power cable, inter unit cable are at least 1 m away fromT.V. radio. This is helpful to avoid
picture disturbance and noise. (Even if 1 m is kept, noise can still appear if radio wave is strong)
(2) Ceiling height
Indoor unit can be installed on ceiling of 2.5-3m in height. (Refer to Foeld setting and Installation Manual of
ornament panel.)
(3) Install suspending bolt.
Check if the installation place is strong enough to hold weight. Take necessary measures in case it is not safe.
(Distance between holes are marked on paper pattern. Refer to paper pattern for place need be reinforced)
(4) Selection of installation location of outdoor
With consent from the user, installation location shall:
• Be sufficient to bear weight of the units, with air circulation.
• Avoid direct radiation from heat sources or other heat sources.
• Facilitate the drainage of condensate. Holes in wall shall also facilitate drainage.
• Be such that noise and heat air will not disturb neighbors.
• Be free of heavy snow in winter.
• Allow air inlets and outlets to be free of barriers.
• Not allow air outlet to directly face strong airflow.
• Facilitate installation at four corners, with 1m space above the unit.
• Be convenient for maintenance and repair.
• For installation of multiple units, sufficient space shall be ensured to avoid short circuit.
• The air conditioner shall not be mounted on a non-dedicated metal frame (e.g. burglar mesh) .
• When the outdoor unit is installed on a street side, its height shall not be less than 2.5m.
≥1500
I
Space required for installation (unit: mm)
≥1500
Model H(mm) I(m)
ABH071H1ERG
ABH090H1ERG 246 2.5≤I≤3.5
ABH105H1ERG
ABH125K1ERG
288 2.5≤I≤4.2
ABH140K1ERG
24
Smart Power
≥1500
≥1500