Deif AWC 500 Installation Instruction page 9

AWC 500 Installation instruction
LEDs:
Terminals:
Cabling:
4.1.2. Safety
The PCM/PDM module is further equipped with one digital input and one relay output.
The input can be used to notify the PCM/PDM whether or not other systems are OK.
The relay output is typically used in wired safety chains.
IN:
Terminals:
Cable:
4.1.3. EtherCAT
The PCM/PDM offers different features to interconnect AWC 500 racks or to connect third party
EtherCAT components.
All PCM/PDM modules offer two EtherCAT OUT ports (Port 1 and Port 2). These are used to connect
directly to other distributed AWC 500 racks with PDM modules or to third party EtherCAT components.
The PDM module additionally offers one EtherCAT IN port (Port 0). The ports are either 100Base-TX
(twisted-pair) or 100Base-FX (Fibre).
Table 5. Shows which EtherCAT interfaces are offered on the PCM/PDM modules.
PCM5·2
PDM5·1
www.deifwindpower.com
Two tri-coloured diodes, one for each power input:
Green
Voltage is above the operating threshold and power is
sourced from this input.
Orange
the voltage of the secondary input is above the operating
threshold and the PCM is ready to source from this input.
Red
Voltage below threshold.
Spring cage plug-able connectors
0.2...2.5 mm
High : 9...36 V or -9...-36 V with reference to common Low : -5...5
V with reference to common. Impedance: approximately 4 kΩ
Spring cage plug-able connectors
0.2...2.5 mm
Table 4
100Base-TX (twisted-pair)
Port 2 (OUT)
Port 2 (OUT)
2
single/multi-stranded wire
2
single/multi-stranded wire
shows which modules offer which interfaces.
100Base-FX (Fibre)
Port 1 (OUT)
Port 0 (IN), Port 1 (OUT)
4.1. PCM5·2/PDM5·1 module
Page 7 of 14