Deif AWC 500 Installation Instruction page 10

AWC 500 Installation instruction
LEDs:
Terminals:
Cabling:
4.1.4. Ethernet
Ethernet at PCM is two standard 1000Base-TX ports that can be used to connect the AWC 500 to a
switched Ethernet network. DEIF does not recommend to connected the PCM directly to the Internet,
hence it should always be placed behind proper updated and maintained security equipment (firewall
etc.) as demanded by the specific use case.
Please consult the AWC 500 Getting started manual for establishing network connection.
LED:
Terminals:
Cabling:
4.1.5. CAN (PCM5·2 only)
The PCM5·2 has two CAN/CANopen ports.
The ports can be configured to operate at speeds from 10000 bps to 1000000 bps.
Terminals:
www.deifwindpower.com
Each interface has a green-coloured diode showing link and/or
activity:
Off
No link
Solid
Link, no activity
Blinking
Link and activity (normal operation)
100Base-TX: Shielded 8P8C ("RJ45") 100Base-FX: SC duplex
connector 100Base-TX: Shielded Category 5, maximum length 100
m 100Base-FX: Multimode fibre, 62.5 μm, OM1, maximum length
2,000 m
2
0.2...2.5 mm single/multi-stranded wire
The Ethernet ports has a green-coloured diode showing link and/or
activity:
Off
No link
Solid
Link, no activity
Blinking
Link and activity (normal operation)
1000Base-TX: Shielded 8P8C ("RJ45")
Shielded Category 5 or higher, maximum length 100 m
Spring cage plug-able connectors.
4.1. PCM5·2/PDM5·1 module
Page 8 of 14