Chapter 6 | Operation; Configuring The Transmitter - Oldham OLCT 80 User Manual

Chapter 6 | Operation
The operations explained in this section must be performed
by authorized, qualified personnel because they could affect
detection reliability.

Configuring the transmitter

Configure the sensor following the standard steps described in the table below:
Step Description
1. System date and time.
2. Main sensor.
ANA1 sensor (if used).
3.
ANA2 sensor (if used).
4.
5. Settings for the main sensor's alarms.
6. Settings for the #1 input alarms, ANA1 sensor.
7. Settings for the #2 input alarms, ANA2 sensor.
Conditions triggering the Rel1 relay.
8.
Conditions triggering the Rel2 relay.
9.
10. Conditions triggering the fault relay.
11. Configure the RS485 connection (if used).
12. Configure the LCD backlighting.
Change the code to access the configuration
13.
menus.
14. Zero and calibration gas test for the main sensor.
15. Calibration test for the ANA1 sensor (if used).
16. Calibration test for the ANA2 sensor (if used).
See section See page
Date and time 22
PG sensor 26
PG CH1 27
PG CH2 30
AL SENSOR 31
AL CH1 32
AL CH2 34
RELAIS 1 35
RELAIS 2 37
RELAIS D 37
PG SERIE 38
PG SERIE 38
PG PASSW 41
Cal sens. 45
Cal CH1 48
Cal CH2 48
6 – Operation
69