Start-Up - Oldham OLCT 80 User Manual

Start-up

Follow safety rules for opening explosion-proof equipment
(hot-work permit, etc.) when powering and coupling the
system.
Figure 52: buttons and indicator lights on the master receiver.
Follow the steps below:
1. Check that the addresses have been configured properly (rotary switches,
OLCT 80 wireless cards (Figure 50, A and B) and master receiver wireless
cards (Figure 52, D).
2. Turn on power to the OLCT 80s and the master receiver.
3. On the master receiver (see: Figure 52: buttons and indicator lights on the
master receiver.press three times fast on the button marked "E" in the figure.
The two LEDs (B and F) blink on and off in red and the LCD screen (C)
displays the words "BINDING" and " MASTER."
4. On the OLCT 80 wireless card (see Figure 53: OLCT 80 wireless
card.press three times fast on the coupling button marked "A" in the figure.
The LED (B) will change from red to green and then orange for 4 seconds
before blinking 4 times to indicate that it has found the master receiver.
Once the coupling code transmitted by the master receiver is received, the
wireless card will automatically exit coupling mode.
Figure 53: OLCT 80 wireless card.
5 – Wireless Version
66