Cal CH1
Calibrate the sensor connected to the ANA1 inlet (see the documentation for
this sensor) with the relays blocked for 5 minutes. The two indicators lights (
and
) will blink.
The AL1 and AL2 alarm indicator lights will be activated if the threshold is
exceeded. They will turn off automatically once the value falls below the
setpoint.
How to access
See Figure 31.
Cal CH2
Calibrate the sensor connected to the ANA2 inlet (see the documentation for
this sensor) with the relays blocked for 5 minutes. The two indicators lights (
and
) will blink.
The AL1 and AL2 alarm indicator lights will be activated if the threshold is
exceeded. They will turn off automatically once the value falls below the
setpoint.
How to access
See Figure 31.
3 – Menus
48