Oldham OLCT 80 User Manual page 71

Example: one OLCT 80 transmitter with one ANA1 input used:
Address of the main sensor: 1.
Address of the ANA1 sensor: 2.
Address of the OLCT 80's internal wireless card: 51 (i.e., 50 + 1).
The @50 address is reserved for the master receiver.
Configuring the addresses of the OLCT 80's wireless cards
To configure the address of the OLCT 80's wireless card, move the 10s-place
switch (B) and the 1s-place switch (A) to the desired values (i.e., 51 in the case
of the example above).
Figure 50: configuring the address of the wireless card.
Configuring the addresses on the master receiver
Selecting the address for the master receiver wireless cards
The master receiver's address must be set to @50.
Figure 51: configuring the master receiver's address to @50.
5 – Wireless Version
65