Installation - Digigram IQOYA *SERV/LINK User Manual

An audio bus can also be selected as the audio source of an input program (like an audio input), so that it can be
streamed as an IP Service.

5. INSTALLATION

5.1. Grounding the IQOYA *SERV/LINK
Attach a ground wire to the chassis (ideally the ground wire has a ring terminal).
Connect the other end of the ground wire to a good electrical ground point.
Once IQOYA is installed and properly grounded, you can connect the Eth ports and audio I/Os as required for
your installation.
5.2. Connecting the audio I/Os and synchronization clocks
In case your IQOYA features analog and/or AES/EBU I/Os, audio connections are available from connectors
"Audio Port 1" for *SERV/LINK882 and *SERV/LINK881, and from both connectors "Audio Port 1" and "Audio
port 2" for *SERV/LINK16162, 24241 and 32321. Please connect the audio I/Os as follows:
● Mono analog input signals 1 to 8 must be connected to inputs 1 to 8 of the breakout cable connected to
"Audio I/O port 1".
● Stereo AES/EBU input signals 1 to 4 must be connected to AES/EBU inputs 1 to 4 of the breakout cable
connected to"Audio I/O port 1"
● Mono analog input signals 9 to 16 must be connected to inputs 1 to 8 of the breakout cable connected to
"Audio I/O port 2"
● Stereo AES/EBU input signals 5 to 8 must be connected to AES/EBU inputs 1 to 4 of the breakout cable
connected to"Audio I/O port 2"
● External synchro signal (AES clock, WordClock, Blackburst video reference) must be connected to the
corresponding synchro connector of the cable connected to "Audio I/O port 1".
Warning​ : In case you use an IQOYA *SERV/LINK 16161, 24241, or 32321 (which are AES/EBU only versions),
the WordClock output from "Audio I/O Port 1" must be connected to the WordClock input of "Audio I/O Port 2".
In case your IQOYA *SERV/LINK features a MADI connection, connect the MADI input fiber to MADI IN
connector, and connect the MADI output fiber to MADI OUT connector.
Connect the WordClock signal to the WordClock input BNC connector.
5.3. Connecting IQOYA *SERV/LINK to the network
We recommend that the first connection to the IQOYA codec is done on a LAN. The default IP addresses of
IQOYA *SERV/LINK Eth ports are:
● Eth0: 192.168.0.100
● Eth1: 192.168.1.100
IQOYA *SERV/LINK user manual
15