Digigram IQOYA *SERV/LINK User Manual page 33

DHCP
IPv4 address
Subnet mask
Gateway
Primary DNS
Secondary DNS
9.1.3.2. Preferences -> Network-> VLAN
This page allow declaring VLANs on the Eth interfaces. No VLAN is declared by default.
We recommended to avoid the "Auto-negotiation" mode. Select the
mode supported by the network node connected the IQOYA.
Read/Write Allows enabling/disabling DHCP (Dynamic Host Configuration
Protocol). Default value is OFF (disabled).
Click on "On" to enable DHCP. This mode disables the following
parameters.
Read if DHCP is On DHCP Off
Write if DHCP is Off Default value is 192.168.0.100 for Eth0, and 192.168.1.100 for Eth1.
Enter the IP address of this Eth interface.
DHCP On
Displays the IP address automatically set through DHCP.
Read if DHCP is On DHCP Off
Write if DHCP is Off Enter the mask of the subnet this Eth port belongs to.
DHCP On
Displays the subnet mask automatically set through DHCP.
Read if DHCP is On DHCP Off
Write if DHCP is Off Enter the gateway IP address. Streams sent through this interface
will go through this gateway.
DHCP On
Displays the gateway IP address automatically set through DHCP.
Read if DHCP is On DHCP Off
Write if DHCP is Off Enter the IP address of the used DNS (if any).
DHCP On
Displays the IP address of the DNS set through DHCP.
Read if DHCP is On DHCP Off
Write if DHCP is Off Enter the IP address of the secondary DNS (if any).
DHCP On
Displays the IP address of the secondary DNS set through DHCP.
IQOYA *SERV/LINK user manual
33