Digigram IQOYA *SERV/LINK User Manual page 16

In case you do not know the IP addresses of the IQOYA *SERV/LINK unit you want to connect to, you can read
its IP addresses from the front panel (see paragraph "LCD display and keypad").
Make sure all other devices connected to this LAN are in the same subnet and have different IP addresses (this
includes the PC from which you will connect to the IQOYA codec to configure).
5.4. Powering up IQOYA *SERV/LINK
It is recommended to establish all connections before powering the device up.
IQOYA *SERV/LINK features two hot swappable redundant power supply units. It is recommended to connect the
two power cords. However, only one cord may be used.
IQOYA *SERV/LINK starts as soon as it is connected to the mains.
Using only one power supply unit triggers the buzzer of the power supply units.
Connecting the second PSU stops the buzzer.
In case the second PSU is not used, stop the buzzer by pressing the red button labelled "R.A" on the back panel.
Note that this does not turn off the "Error" LED on the front panel and the PSU alarm on the LCD and WEB GUI.
5.5. Steps to follow to configure IQOYA *SERV/LINK
Set the global parameters of your IQOYA *SERV/LINK
If IQOYA is used for encoding:
● Adjust the parameters of the audio inputs
● Declare the programs
● Declare the IP services to be streamed over IP
Note that one program can be used by only one IP service.
If IQOYA is used for decoding:
● Adjust the parameters of the audio outputs
● Declare the IP services to be received from the network
● Declare the programs to be decoded from the received IP services
● Check the statuses and metrics on the output programs.
If IQOYA is used for transcoding:
IQOYA *SERV/LINK user manual
16