Digigram IQOYA *SERV/LINK User Manual page 63

Audio outputs: First audio
bus
Number of outputs
The following parameter define the audio source associated to priority 1. It is possible to declare two additional
priorities by clicking on the button
The parameters listed for a decoding priority depend on the selected source "Type": IP service, File, Playlist,
Audio input.
Source Type = IP service, and IP service is RTP
Type
Service
Received format
auto-detection
Disabled
Note that it is necessary to select an audio output that is not assigned to
another program (an error is displayed)
Read/Write Select the first audio bus channel associated to this program.
Audio bus is useful for IP stream transcoding.
Read/Write Set this parameter to 1 for mono, 2 for stereo, 6 for 5.1, 8 for 7.1.
on the right below the decoding priority.
Read/Write Select the audio source for this priority.
IP Service​ : audio will be extracted from a declared IP service.
File: audio source is a local file
Playlist: audio source is a local "m3u" playlist
Audio input: audio source is an audio input.
Read/Write Select the IP service from the list of declared IP services.
(IP services must have been declared first from the IP Services page).
Read This parameter is set automatically according to the selected IP service.
If the IP service has been declared with in-band format signalling,
auto-detection is set to "Yes".
Read/Write Set this parameter to "Yes" to disable this decoding priority. Disabling a
define priority is useful when some servicing is in progress on it (network
servicing, servicing on the source of the IP stream). The priority can then
be enabled when servicing operations are finished.
IQOYA *SERV/LINK user manual
63