Digigram IQOYA *SERV/LINK User Manual page 55

Program: Delay for PTS
calculation
Program: Overall bit rate
Program: Transport
Protocol
Audio stream: IP address
Audio stream: Port
Audio stream: Network
interface/VLAN
Audio stream: Local source
port
Audio stream: DSCP
Click on the icon on the bottom right of the page to add an IP destination.
Click on "Save" to confirm the settings. Click on "Save & New" to confirm the settings an create a new IP service
with the same parameters.
Click on "Close" to discard the settings.
Read/Write Enter the relative delay to be used to calculate the Presentation Time
Stamp (100 to 2000ms)
Read/Write Enter the overall bit rate of the MPEG-TS stream.
When set to 0, the bit rate is set automatically.
Read/Write Streaming protocol of the MPEG-TS stream: RTP or UDP.
Read/Write Enter the destination IP address (unicast or multicast)
Read/Write Enter the destination UDP port.
Read/Write Select the network interface or VLAN for this stream.
In case the target address is unicast, select "Any" so that the Eth interface
is determined automatically according to this IP address, or select a VLAN.
In case the target IP address is multicast, select the Eth interface or the
VLAN.
Read/Write Local UDP port number of IQOYA *SERV/LINK
Read/Write Select the quality of service (QoS) class of the stream.
IQOYA *SERV/LINK user manual
55