Outputslopemanualadjustment[ A-Ga ]; Base-Up[ B-Up ] - Autonics DPU Series User Manual

6.Parametersettingandfunctions
6.2.5 Outputslopemanualadjustment[ A-GA ]
This function is to adjust manually (internal or external VR) output value ratio for control input.
When setting AUTO GAIN function as ON in AUTO operation, [ SLOP ] is not displayed. It displays
slope value by the internal or external VR input.
Output(%)
• Output slope manual adjustment [ A-GA ] setting as ON: Set output slope by the inner 3- level
slide switch
Type
MAN
INT
MAN
EXT
AUTO
6.2.6 Base-up[ B-UP ]
This function is to add base-up set value to input signal.
It is available only when output low-limit value is 0%.
Output(%)
When setting base-up, output value is input (%) X slope value + base-up set value. It is limited by
start limit value at initial start.
• Set range: Base-up set value (%) < Output high-limit value
34
Control input signal(%)
Description
Adjust output slope with the internal VR
Adjust output slope with the external VR
No function
BASE-UP SV(%)
Control input signal(%)
100% of internal or
external VR
50% of internal or
external VR
©CopyrightReservedAutonicsCo.,Ltd.