Autonics DPU Series User Manual page 7

● Caution for usage (Do not install this unit at the following places.)
The place where ambient temperature is over -10 to 50℃ range.
The place where ambient humidity is over 5 to 90%RH.
The place where temperature changes are rapid and there is dew condensation.
The place where there is corrosive gas (especially oil gas, ammonia, etc), or flammable gas.
The place where there is vibration or shock to the unit.
The place where there is water, oil, drug, or steam.
The place where there is lots of dust and dirt, salinity, or iron.
The place where big inducement malfunction, static, or magnetism noise occurs easily.
The place where there is direct ray of the sun.
The place where thermal heat builds up by radiant heat.
Do not open the cover automatically to move this unit.
● Installations
Tighten this unit with bolts as accessories on the panel.
If water enters this unit, you must inspect this unit. It may cause short circuit, or a fire.
When installing this unit, use safety protections such as safety shoes, and helmet, etc and be
sure that the safety.
Be sure that not to put the legs or sit on this unit.
● Temporary storage
Fix this unit with transportation screws to store this unit temporarily.
Store this unit as below environments.
The place where there is no dregs, flammable gas, explosive gas (SO
The place where there is no vibration, shock
The place where there is no steam or not too much hot humidity (95%RH)
The place where it is not extreme low temperature (below -20℃)
● Caution for wiring
Do not use empty terminals during wiring I/O to other usage.
Consider a countermeasure for lots of noises.
● Cleaning
In cleaning the unit, use dry cloth.
Do not use organic solvent.
Turn off the power to clean this unit.
Thespecifications,dimensions,etcaresubjecttochangewithoutnotice.
©CopyrightReservedAutonicsCo.,Ltd.
SafetyPrecautions
, H SO, etc).
2 2
vii