Table of Contents
Advertisement
22
TWS TOWER ASSEMBLY GUIDE
Fig. 18
Fig. 19
Fig. 20
Your pole system comes preassembled
with the push-through bar installed.
Installing the Poles:
1. Before you assemble the pole system
to the head end of the frame, make
sure that the set screws in the frame's
fittings are backed completely out
of the center holes and that there
are no obstructions present. Doing
so will prevent the poles from being
scratched during installation. (Fig. 18)
2. This step is best performed by two
people. With one person on each
side, lift the pole assembly. Orient the
assembly such that the series of 3
eyebolts on each of the vertical poles
faces toward the foot end of the TWS
frame. (Fig. 19)
3. Slide the poles through the fittings.
You may need to gently jostle the
pole system back and forth for the
poles to be able to pass all of the way
through. Be sure that the poles rest on
the eyebolt located below the bottom
fittings. (Fig. 20)
4. Tighten the 8 set screws with the 3/16"
hex key provided.
Hide quick links:
Advertisement
Table of Contents
