Table of Contents
Advertisement
Tower Bracket Spacer Installation
Fig. 32
Fig. 33
Fig. 34
The final step for attaching the tower
to the frame is the installation of
tower bracket spacers. Please find the
instructions for installing these spacers
below:
1. Take the tower bracket spacer and
place it inside the rail of the reformer
(Fig. 32)
2. Place the hex key in the top hole of
the tower bracket spacer, then gently
lower the spacer into the tower
bracket. (Fig. 33)
3. Insert the 45mm screws with one
small washer per screw into the four
holes on the outside of the tower
bracket. Screw in the 45mm screws
until they are finger tight. (Fig. 34)
Note: Use the hex key to align the
holes while the tower bracket spacer
sits inside the tower bracket.
4. Now tighten all 16 screws attaching
the tower to the reformer frame
with the 5mm hex key until they
are completely tight and secure.
Note: Be sure to not overtighten.
(Fig. 35)
Fig. 35
Hide quick links:
Advertisement
Table of Contents
