Table of Contents
Advertisement
Reinstalling the Push-Through Bar
Now that the tower is attached and secure to the reformer frame, you can now
reinstall the push-through bar onto the tower. To re-install the push-through
bar, please follow the instructions below (Note: these steps require at least two
people):
1. Position the push-through bar at one of the three sets of holes in the tower.
2. Press the circular button at the top of the black handle to release the pins.
3. Insert the pins into the holes until they lock into place.
Fig. 36
Fig. 37
Long wood trim
Tower caps
Fig. 38
Installing the Wood Trim
Artistry
Reformers come with four
TM
wood pieces to cosmetically connect
the classical wooden frame with the
modern metal tower. The instructions for
installing this optional wooden trim are
below:
1. Take the wooden blocks and
remove the protective covering
from the double-sided tape. (Fig. 36)
2. Press the wooden blocks into the
tower extrusions. (the lower right-
hand corner is shown Fig. 37)
The long wood blocks should be
inserted in the horizontal extrusions at
the top of the tower (on both sides). The
short wood pieces should be inserted in
the lower right- and left-hand corners of
the tower (only on the side that faces the
reformer frame).
Tower Cap Installation
The tower also comes with four circular
plastic tower caps that protect the
metal frame when it is un-installed from
the reformer and resting against other
surfaces like the floor. Simply insert the
caps into the four holes on both sides of
the top two corners of the tower. (Fig. 38)
Hide quick links:
Advertisement
Table of Contents
