Installing The Springs, Carriage, Gear Bar - Peak Pilates ARTISTRY SERIES Assembly And Owner's Manual

INSTALLATION
Artistry™ Reformer frames come preassembled, are hand-crafted in oak and
finished with lacquer for a long-lasting shine as well as protection against sweat
and water damage. Two or more people should assist with moving and placing the
reformer frame in the desired location for use.
Installing Springs
The reformer comes with either four reformer springs that have all the same
medium-level tension, or five reformer springs that have varying levels of tension.
The five springs of varying levels of tension feature different colors near the
eyebolt that denotes the tension rating of each spring.
Blue – Light tension
Yellow – Medium tension
Red – Heavy tension
The eyehooks for attaching the springs come preinstalled on both the carriage
and gear bar. To install the springs, please follow the steps below:
Fig. 1
Installing the Carriage
We recommend that the springs be attached to the carriage prior to installing the
carriage in the frame.
Please follow the steps for placing the carriage into the frame below. These steps
should also be completed by two or more people.
CO LLEC TI O N OWN E R' S MANUAL
TH E A RTI S TRY TM
1. Flip the carriage over and locate the
eyehooks.
2. Unpack the springs, being careful
not to scratch the coils during the
unpacking.
3. Hook the non-color coded ends of
each spring to the eyebolts located on
the carriage, making sure that they rest
against the spring support bar.
Note: The springs should rest between
the small grooves found on the bottom
of the spring support bar (Fig. 1).
15