1. Manuals
  2. Brands
  3. Peak Pilates Manuals
  4. Fitness Equipment
  5. MVe Chair
  6. Assembly & user's manual

Peak Pilates MVe Chair Assembly & User's Manual

Single and split pedal
Hide thumbs
Table of Contents

Advertisement

Quick Links

MVe
Chair
®
Single Pedal
Split Pedal

Advertisement

Table of Contents
loading

Related Manuals for Peak Pilates MVe Chair

Summary of Contents for Peak Pilates MVe Chair

  • Page 1 Chair ® Single Pedal Split Pedal...

  • Page 2: Recommended Use

    This manual contains important safety and usage information. Before beginning exercise, read the entire manual paying spe- cific attention to all cautions and warnings. Obtain qualified instruction on the use of the Peak Pilates MVe Chair. Use only for the intended exercise.

  • Page 3: Safety Statement

    Safety Statement It is the responsibility of the purchaser of Peak Pilates products to instruct all individuals, whether they are end users or supervising personnel, on the proper use of the equipment. Inspect the machine including Springs, Pull Pin, and Release Pins before use. DO NOT exercise on the machine if signs of excessive wear or other defects are evident.

  • Page 4: Assembly Instructions

    Assembly Instructions 1. Carefully unpack and inspect the contents of the box. Use extreme care when cutting away the packing materials as the cutting tool/tools can scratch the surface of the parts. Split-Pedal Base Assembly 2. Verify that you have received all parts and hardware by checking what is included in the box against the packing list below.
  • Page 5 6. Place the Front Leg over its holes near the front edge of the Seat. Again the Leg is sy- metric. Start one M10 x 1.5p x 25mm long sockethead cap screw in each of its three holes. Thread the screws but do not fully tighten at this time. 7.
  • Page 6 13. Tap the end of the E-Clip with the back of a screw driver, small hammer or other tool until the clip snaps over and is fully seated within the groove of the Pin. 14. While holding the free ends, pull up on the Springs (the Foot Bar will follow) placing the loops into the notches in the Spring Support Bracket located under the Seat.
  • Page 7 User Guide TO ADJUST THE SPRING TENSION: 1. While holding the Spring Adjustment Slider cylinder with your left hand, pull the Pull Pin with your right. 2. Slide the cylinder to the desired location on the Foot Pedal vertical tube. Note: The num- ber for the locating hole will appear directly above the top edge of the cylinder.
  • Page 8 TO STACK THE MVe CHAIR: Note: Before stacking a Split-Pedal Chair, verify that the pedals are engaged (see “TO ENGAGE SINGLE PEDAL MODE” above). 1. Place the Spring Adjustment Slider/Sliders in position #4, the top hole in the Spring Adjust- ment Slider Guide.

  • Page 9: Periodic Maintenance

    We recommend a mild detergent and water solution to clean the vinyl of the seat and the aluminum frame. The Springs on the MVe Chair must be inspected a minimum of once per month. If the coils show any signs of separating, they must be im- mediately replaced.

  • Page 10: Contact Information

    Contact Information: 5555 Central Avenue, Suite 200 Boulder, Colorado 80301 303.998.1531 (Worldwide) (+1) 800.925.3674 (North America) (+1) 303.473.9142 (Fax)

Table of Contents