Attaching The Reformer Springs; Adjusting The Gear Change Bar - Peak Pilates Deluxe Reformer Assembly Manual

Attaching the Reformer Springs

The Peak PilateSystem comes with 5 Reformer Springs
attached to the Carriage.
There are 3 types of springs described below.
• Light - There are 2 light springs marked with a blue tab.
• Medium - There are 2 medium springs marked with a yellow tab.
• Heavy - There is 1 heavy spring marked with a red tab.
Warning: At least one spring must be attached at all times while the Peak PilateSystem is in the Reformer mode.
To attach the spring to the eye bolt on the Gear Change Bar:
1. Pull and lift the spring.
2. Insert the spring hook through the respective eye bolt.

Adjusting the Gear Change Bar

1. Remove all springs from the Gear Bar.
2. If moving the Gear Bar toward the Carriage, pull the Release Levers
toward the center of the unit and slide the Gear Bar to the
desired positions.
3. If moving the Gear Bar toward the Foot Bar, simply push the Bar into Place.
4. Roll the Carriage toward the Head End of the machine exposing the
Gear Block.
5. Pull the Gear Block upward as far as possible and slide to the location
commensurate with the Gear Bar. The Gear Block will automatically
engage when properly positioned.
6. Re-engage the springs as required.
Caution: Make sure that Gear Change Bar locating pins are securely engaged in one of the 4 positions before exercising.
24 Peak PilateSystem Assembly Guide
®