Table of Contents
Advertisement
Image 8-43: Blend & Mask menu
2.
To enable blending, put the Enable switch to the right. The color of the switch becomes blue when enabled.
3.
To project masking lines on the screen, put the Show lines switch to the right. The color of the switch
becomes blue when enabled.
4.
Determine the start position of the mask (1) for the masking height and width, together with the desired size of
the mask (2) to determine the width of the masked area.
When the blending lines are activated, you will get a visual indication of the screen of the installed blending
area.
2
1
Image 8-44
1
Start position (mask)
2
Blending width
5.
Select one of the four starting positions values with the arrow keys and confirm.
6.
Use the arrow keys or remote digits to change the value of the mask and confirm.
7.
Repeat this process for the desired width/height value.
8.
Repeat this process for all other desired sides.
Do not forget to disable the Show lines button after you achieved the desired blend zone.
GUI – Installation
R5906151 /02
XDL
89
Advertisement
Table of Contents
