Table of Contents
Advertisement
Type of layout
1 2 3 4
: Quad 1 x 4
1
: 2 x single
1
2
: 2 x Dual 1 x 2
Even if passive stereo sources are selected, the output of this projector can only be in either 2D or
in Active Stereo. Advanced image processing will make sure a passive stereo image is properly
converted to active stereo.
How to select a stitched layout
1.
Press Menu to activate the menus and select Source.
Image 6-2: Select Source
2.
Press OK.
The Select Source menu is displayed with the actual available sources filled out, including all available
stitched layout options.
Image 6-3: Input selection menu
3.
Select the desired stitched input.
Tip: If the V&AR board is installed, scroll all the way down the Input Selection menu for the stitched
options on that board.
Description
Four inputs are required. The
sources are displayed next to
each other.
Two inputs are required. The
sources are displayed one
above the other.
Four inputs are required. Two
sources are displayed next to
each other, while the other two
are displayed above the first
two
Available connectors
Quad DP 1.2 Input:
•
4x DisplayPort
Quad DP 1.2 Input:
•
2 x DisplayPort
Quad DP 1.2 Input:
•
4x DisplayPort
R5906151 /02
GUI – Source
Mode
Mono / Active
stereo
Passive stereo
Passive stereo
XDL
59
Advertisement
Table of Contents
