CS-Lab CSMIO/IP-A Manual page 100

Z position and type on your keyboard "0.2 <enter>".
After this operation, we can start work from the second file not forgetting about the measurement after
tool change („Auto Tool Zero" button).
When the file is loaded, and the tool is measured we can set the axes again over the material with the MDI
like before.
Press „Cycle Start" and start the treatment.
The photos below show the work piece during the process, after work and after it is finished with gentle
sanding with emery paper.
C S - L a b s . c . – C S M I O / I P - A - C N C c o n t r o l l e r Page 100