Advanced Control Parameters - Gree CE52–24/F(C) Owner's Manual

Centralized Controller
2) Heat recollection system have no master indoor unit. When the indoor unit of
the same branch is connected into one indoor unit, the auto mode can be set;
when the quantity of indoor unit in the same branch is more than one set, the
auto mode cannot be set; other modes can be freely switched.
(3)Temperature setting
Press the up or down buttons to adjust temperature. Each time pressing the button
will increase/decrease the temperature by 1. Holding down the button can
increase/decrease temperature continuously.
Pressing the button can display the "indoor temp" and "outdoor temp".
(4)Fan speed setting
Press the fan speed button to set umatch unit fan speed.
Note: Unit defaults to low fan speed in drying mode. Fan speed cannot be set in
drying or floor heating mode.
(5)Swing setting
Pressing the button "Up&Down Swing" or "Left&Right Swing" can turn on or off the
swing function.
Note: Swing types for indoor units of different series are not all the same.
(6)Malfunction View
When indoor unit fails to function well, the will turn red. then press the button to
view the information of malfunctions.
5.7.3

Advanced Control Parameters

Press the advanced button to enter the advanced page.
Press the icons to turn on or off related functions.
(1)The functions of Sleep, Quiet, Auxiliary Heating, Absence, Energy Saving are only
effective under ON status.
(2)Absence function can only be enabled in Heat mode. When Absence function is
enabled, set temperature is 8℃.
Figure 5-10 Umatch unit advanced page
24