Table of Contents
Advertisement
6 Control Flow Chart
See the following figure for the control flow chart of the smart zone controller.
No press operation in 30 seconds
Center
Single
Note: As for first energization, or change of process setting, or change of series port, it should
be adjusted again (see 5.3 for the method).
7 Viewing of the Running Status of the Indoor Unit and Control Mode
7.1 Viewing of the Running Status of the Indoor Unit
It can be seen generally on the LCD that the minimum code of the online indoor unit flashes,
with its running status, set temperature, and shield status etc. displayed. However, it can be
replaced by other expected indoor unit through pressing the corresponding indoor unit code button.
(If the expected indoor unit is offline, then this operation is null and void with "no" displayed.).
(No press operation in 2.5 seconds)
Centralized
(No press operation in 2.5 seconds)
(No press operation in 2.5 seconds)
Fig. 6.1 Control Flow Chart of the Smart Zone Controller
Floor Ceiling Air-Conditioning Unit
Set the control comma nd
Set the control comma nd
All on/All off
13
Send out the control command
Send out the control command
Send out the control command
Advertisement
Table of Contents
