Engineering Setting - Gree CE52–24/F(C) Owner's Manual

Centralized Controller
(5)Backlight setting
Pressing this button can set the timeout period of screen backlight. Screen will be
shut off and the centralized controller will enter sleep mode when the timeout
period is over.
Note:When centralized controller is in sleep mode, use can wake it up by touching
any part of the touch screen or the touch button at the right bottom of the screen..
(6)Brightness
Pressing or dragging the sliding bar can adjust the backlight degree.
(7)Customer Service
User can set the name and phone number of the local customer service center for
the convenience of acquiring immediate solutions and technical support.
Press the button to save the setting.
(8)Restore default settings
Press the "Reset" button to restore local setting, e-Control setting, group setting,
schedule setting, names and icons of indoor units, and other relevant ex-factory
default settings.
1) When switching between indoor network and outdoor network, or reset unit IP,
restore the ex-factory setting for centralized controller.
2) After debugging for the centralized controller is finished, connect in to the
network. If connect the centralized controller to the network during debugging
process, it needs to restore the defaulted ex-factory setting.
5.9

Engineering Setting

On the home page, press
Press the "Project Setting" button to switch to engineering setting, the operation
method is the same as the setting of this unit.
(1)Indoor unit register
Enter into the indoor unit register interface, select the chosen indoor unit according
to the displayed engineering No. of indoor unit icon, and then press
will display the registered indoor unit in the indoor unit page.
Notes: There are 255 sets of indoor units can be registered at most.
to enter into setting page.
26
to save, it