Installation Procedure - Gree CE52–24/F(C) Owner's Manual

2) When setting is over, press "OK/Cancel" or "Swing/Enter" to save the setting
and exit. Under the setting status, if no action is taken within 20 seconds,
system will exit from the setting and return to the display mode of OFF status.
Setting can't be saved in this case.
(4)Communication method of umatch units must be long-distance monitoring mode,
else can not communicate with centralized controller, set the way as follows.
1) Under OFF status, press "Function" and "Timer" on the wired controller
simultaneously for 5S to enter the setting of long-distance monitor. Adjust by
pressing the "Up" and "Down" buttons.
2) When setting is over, press "OK/Cancel" or "Swing/Enter" to save the setting
and exit. Under the setting status, if no action is taken within 20 seconds,
system will exit from the setting and return to the display mode of OFF status.
Setting can't be saved in this case.
Note: Address setting and long-distance monitor setting of unitary units can only
be achieved through wired controllers.
3.3

Installation Procedure

Figure 3-8 Installation Diagram
9
Centralized Controller