General Control Parameters - Gree CE52–24/F(C) Owner's Manual

Centralized Controller
Parameters of single unit control include parameters of general control and advanced
control.
5.3.1

General Control Parameters

(1)ON/OFF
Press the on/off button to turn unit on or off.
When unit is turned off, mode, temperature, fan speed and swing can't be set.
(2)Mode setting
Press the Mode buttons to set umatch unit operation mode.
Modes for indoor units of different series are not all the same.
If a certain mode is not available in the indoor unit, the icon of the corresponding
mode cannot be selected.
Note:
1) Auto mode can only be set in the master indoor unit.
2) Heat recollection system have no master indoor unit. When the indoor unit of
the same branch is connected into one indoor unit, the auto mode can be set;
when the quantity of indoor unit in the same branch is more than one set, the
auto mode cannot be set; other modes can be freely switched.
(3)Temperature setting
Press the up or down buttons to adjust temperature. Each time pressing the button
will increase/decrease the temperature by 1. Holding down the button can
increase/decrease temperature continuously.
Pressing the button can display the "indoor temp" and "outdoor temp".
(4)Fan speed setting
Press the fan speed button to set umatch unit fan speed.
Note: Unit defaults to low fan speed in drying mode. Fan speed cannot be set in
drying or floor heating mode.
Figure 5-2 Control Page of Single IDU
16