General Control Parameters - Gree CE52–24/F(C) Owner's Manual

11 Umatch unit icon
12 Umatch unit name
Before using, press the registration icon and enter the registration page. Register the
Umatch units that are going to be controlled. Centralized controller can support the
control of 36 units at most.
Press and hold umatch unit icon for 5S to enter the page of settings. Then you may
set the name and icon for the unit.
Umatch unit control parameters include general control parameters and advanced
control parameters.
Note:
(1)The functions of group control and engineering setting of the Centralized controller
are only applicable to multi VRF units. Umatch units do not have the above
functions
(2)when in the fuction of All-central control,all the Mulit-VRF unit and umatch unit are
controllered,but umatch unit not controllered by advance seting.
5.7.2

General Control Parameters

(1)ON/OFF
Press the on/off button to turn unit on or off.
When unit is turned off, mode, temperature, fan speed and swing can't be set.
(2)Mode setting
Press the Mode buttons to set umatch unit operation mode.
Modes for indoor units of different series are not all the same.
If a certain mode is not available in the indoor unit, the icon of the corresponding
mode cannot be selected.
Note:
1) Auto mode can only be set in the master indoor unit.
Display the current umatch unit icon
Display the current umatch unit name
Figure 5-9 Control Page of Single umatch unit
23
Centralized Controller