Omron SYSMAC CS Series Operation Manual page 61

Outline
Category Type Block
Model
Operation Others 192
Block (con- (See note
1.)
tinued)
Sequence 201
Operation
(See note
1.)
202
(See note
1.)
203
(See note
1.)
205
(See note
1.)
206
(See note
1.)
207
(See note
1.)
208
(See note
1.)
209
(See note
1.)
210
(See note
1.)
Contact 221
Type Con-
trol Target
222
223
224
225
Sequential 301
Control (See note
1.)
302
(See note
3.)
Block Name
Analog/Pulse Changes the ON/OFF duration ratio in a
Width Converter constant cycle duration so that it is propor-
tional to the analog signal.
Contact Distrib- Connect contact signals between function
utor blocks in a 1: 1 connection.
Constant Com- Compares up to eight sets of analog sig-
parator nals and constants, and outputs the com-
parison results as contacts.
Variable Com- Compares up to eight pairs of analog sig-
parator nals, and outputs the comparison results as
contacts.
Timer 2-stage output type addition timer for fore-
cast values and reached values. Can also
output the present value.
ON/OFF Timer Timer for performing ON-OFF operation at
preset ON and OFF times.
Clock Pulse Manipulates and monitors ON/OFF valves
with open/close limit switches.
Counter 2-stage output type addition timer for fore-
cast values and arrival values. Can also
output the current value.
Internal Switch Temporary storage contact for accepting
relays in the Step Ladder Program block.
(Note: One internal switch is already allo-
cated as "temporary storage" in CX-Pro-
cess Tool.)
Level Check Checks an analog input for 8 levels and
outputs a contact corresponding to the
level. The level number is also output as an
analog value.
ON/OFF Valve Manipulates and monitors ON/OFF valves
Manipulator with open/close limit switches.
Motor Manipula- Manipulates and monitors motor operation.
tor
Reversible Manipulates and monitors reversible motor
Motor Manipula- operation.
tor
Motor Opening Inputs a target opening, and manipulates
Manipulator an electric positional-proportional motor.
Switch Meter Manipulates and monitors multiple devices
(up to 8) such as ON/OFF valves, motors,
and pumps.
Step Ladder Performs logic sequence and step progres-
Program sion control.
Sequence table Conditions and actions are listed in table
format to perform logic sequence or step
progression control.
Note: CS1W-LCB05/05D only; not sup-
ported by the CS1W-LCB01.
Function
Section 1-1
Allocatable Block
Address
LCB05/05D: 001 to 500
LCB03: 001 to 300
LCB01: 001 to 050
LCB05/05D: 001 to 500
LCB03: 001 to 300
LCB01: 001 to 050
LCB01: 701 to 720
LCB03/05/05D: 701 to
900
29