Omron SYSMAC CS Series Operation Manual page 211

Simple Example of Use
4. Wire in the software the analog signals between blocks.
5. Set the ITEMs in each function block.
Set function block initial setting parameters (refer to the item "(S): Initial
setting data" describing how to read/write in the Function Block Reference
Manual) such as direct/reverse action and Set Point setting mode (Re-
mote/Local) on CX-Process Tool.
Operation-related parameters (refer to the item "(O): Operation Data" de-
scribing how to read/write in the Function Block Reference Manual) such
as PID constants may be set either on CX-Process Tool or using SCADA
software.
Section 4-1
179