Installing Splashguards - Hussmann Freedom Line series Installation & Operation Manual

DRIP PIPING / FACADES / SPLASHGUARDS / BUMPERS
3-6

INSTALLING SPLASHGUARDS

The splashguard is shipped inside each mer-
chandiser. a merchandisers have been lev-
fter
eled and joined, and all drip piping, electrical
and refrigeration work has been completed,
install the splashguard.
To Install Splashguards:
1. Check to be sure that all splashguard
brackets are level with the floor.
2. Position top of splashguard with the top
angled in as shown in the illustration. Align
the slots in the upper edge of the splashguard
with the tabs extending downward behind the
splashguard cover.
3. Engage the slots over the tabs and raise the
splashguard while pushing the bottom in.
4. Align the tabs on the splashguard brackets
with the slots in the bottom edge of the splash-
guard. Engage the tabs in the slots and drop
the splashguard into place.
To install the cove trim to the splashguard:
1. Remove all dirt, wax and grease from the
area of the splashguard where adhesion will be
necessary to ensure a secure installation.
2. Apply a good contact cement to the cove
trim and allow proper drying time according to
the directions supplied with the cement.
3. Install the trim to the splashguard so that it
is lying flush with the floor. d
.
Trim To The floor
4. If required by local health codes the Cove
Trim may be sealed to the floor, using a silicone
type sealer. Sealant must be removed and re-
placed when servicing.
P/N 0527427_M
o noT seal The
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
Bracket
Tab
Splashguard
Splashguard
Splashguard
Cement
Cove Trim
Base of
Case
1.
2. & 3.
4.
Trim