Installing Splashguards - Hussmann IMPACT LW Installation And Operation Manual

3-2 DRIP PIPING AND SPLASHGUARDS

INSTALLING SPLASHGUARDS

The splashguard and brackets are shipped inside
each merchandiser.
Install splashguard brackets before piping
merchandiser. Use two screws per bracket; attach
brackets every 4 ft (1219 mm) at pre-drilled loca-
tions.
After merchandisers have been leveled and
joined, and all drip piping, electrical and refriger-
ation work has been completed, install the splash-
guards.
To Install Splashguards:
1. Check to be sure that all splashguard brackets
are level with the floor. Tighten screws.
2. Align splashguard so that slots in the top of
splashguard match the tabs extending from the
base of the merchandiser as shown.
3. Push splashguard up onto tabs until lower
edge of splashguard swings onto bracket.
Lower bottom of splashguard onto bracket tabs.
The end splashguards are installed last, as shown.
P/N 0395730F
Two
screws
per
bracket
Attach retainer
before attaching end
END SPLASHGUARD
ATTACHMENT
End Splashguard
Attachment
HUSSMANN CORPORATION, BRIDGETON, MO 63044-2483 U.S.A.
Bracket
at 4 ft
interval