s
6-2
eRVIce
REPLACING LED CANOPY LIGHT BARS
Route electrical wiring connections for the
single-row canopy. Connection can be made at
the power supply using a molex connector, or
use approved wire connectors or heat shrink
butt connectors. Attach the Canopy LEDs to
the canopy using mounting clips and screws.
NOTE:
One power supply can provide power for as
many as 3 canopy lights.
LEDs (Top View)
EcoShine II
EcoShine II
Multi-Deck Shelf
Multi-Deck Shelf
EcoShine II
Multi-Deck Canopy
EcoShine II Plus
Multi-Deck Canopy
Light Bar Clips
P/N 0527427_M
The light bars are attached to the lamp panel
using clips. Contact your Hussmann represen-
tative to replace light clips if the clips become
damaged, or missing.
The light bars are connected through a two-
conductor connector. Push on the release tab
on the connector, then pull down on the
connector. Do not pull on wires. LED power
source is 24-volts for safety.
REPLACING LED SHELF LIGHT BARS
The LED shelf light bars are held in place with
magnets on the back of the light bar.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900• www.hussmann.com
Canopy LED Light Connector
LED Shelf Light Bar