Hussmann Freedom Line series Installation & Operation Manual page 89

AE8-1376 R5
Label
LS Minimum set point (PSIG)
US Maximum set point (PSIG)
ono Minimum time between two compressor starts (minutes)
nFA Number of fans on during probe fault
Unt Measurement unit for pressure: PSIG, bar, kPA
CF Measurement unit for temperature
on Bump Start Compressor on time (seconds)
off Bump Start Compressor off time (seconds)
nUb Number of cycles during bump start
bEn Compressor stop time for next bump start (hours)
doF DLT alarm temperature to stop compressor (°F)
don DLT temperature for compressor restart (°F)
ALd DLT stop compressor delay (seconds)
Minimum time of compressor off with dLL alarm (minutes)
dlF
AU2 Cut-in for Condenser Temperature/Pressure alarm (°F)
AH2 Cut-out for high Condenser Temperature/Pressure alarm (°F)
Ad2 High condenser temperature alarm delay (minutes)
Minimum off time after a High-Pressure Trip (minutes)
HPF
P1i Start scale for probe 1 (PSIG)
P1E End scale for probe 1 (PSIG)
P1d P1 alarm display delay, with P1C=0-5V (min)
P2P Probe 2 presence
Probe 2 configuration
P2C
P2i Start scale for probe 2 (PSIG)
P2E End scale for probe 2 (PSIG)
Probe 3 configuration
P3C
High condenser temperature alarm with compressor off
Ab2
AUX 1 configuration
oA1
AUX 2 configuration
oA2
© 2015 Emerson Climate Technologies, Inc.
Application Engineering
B U L
Table 5 – Factory Set Parameters
Description
Factory Set Definitions
7-11
L E T I N
May 2016
Default Range
-7 or 5 -7 - US
135 LS - 135
0 0 - 15
2 0 - 2
PSI PSI, bAr, HPA
F C or F
2 1 - 15
5 1 - 15
3 1 - 15
4.0 1.0 - 23.5
220 don - 302
170 -58 - doF
0-5 0 - 255
0 0 - 15
150 AH2 - 230
140 -40 - AU2
0 0 - 255
5 0 - 15
-15 -15 to P1E
135 P1i to 999
0 0 -100
YES, NO
NTC, 0-5
-15 -15 to P2E
485 P2i to 999
Nu, DLT, CPA
Yes, No
Fan, Fn2, Alr
Fan, Fn2, Alr