Viewing The Set Points; Changing A Parameter Value; Entering The Advanced Options Menu; Moving Parameters Between The Programming - Hussmann Freedom Line series Installation & Operation Manual

AE8-1376 R5
2.4 Viewing Temperature Readings
1. Press button to view condenser temperature.
2. Press button to view discharge temperate.
2.4.1 Viewing Setpoints
1. Press and immediately release
display will show the "Cin" message.
2. Press button to see the setpoint value.
3. Press and immediately release
display will show the "CoU" message.
4. Press button to see the setpoint value.

2.5 Changing a Parameter Value

To change a parameter value, do the following:
1. Hold down +
"PSI" LED starts blinking, to enter the Programming
Menu.
2. Press or button to select the required
parameter. Press
value.
3. Press or button to change parameter value.
4. Press button to store the new parameter value.
TO EXIT: Press
seconds without pressing a button or key.
NOTE: The set value is stored, even when the procedure
is exited, by waiting for the time-out to expire.

2.6 Entering the Advanced Options Menu

The Advanced Options Menu will be locked 5 minutes
after the controller is powered. If access to the Advanced
Options Menu is needed, cycle power to the controller.
1. Hold down +
"PSI" LED starts blinking, to enter the Programming
Menu.
© 2015 Emerson Climate Technologies, Inc.
Application Engineering
B U
button: the
button: the
keys for 3 seconds, or until the
button to display parameter
+ keys or wait up to 30
keys for 3 seconds, or until the
L L E
2. Release keys, then hold down
again for at least 7 seconds. The "PR2" label will
be displayed immediately followed by the "Ci.n"
parameter.
NOTE: THIS IS THE ADVANCE OPTIONS MENU.
3. Press or
parameter.
4. Press button to display parameter value.
5. Press or
6. Press button to store the new parameter value.
TO EXIT: Press
seconds without pressing a button or key.
NOTE: If no parameter is present in "PR1" after 3
seconds, the controller will display the "noP" message.
Keep the keys pushed until the "PR2" message is
displayed.
NOTE: The set value is stored, even when the procedure
is exited, by waiting for the time-out to expire.
2.6.1 Moving Parameters between Programming
Menu and Advanced Options Menu
While in the Advanced Options Menu, certain parameters
will have a period between the 2 nd and 3 rd characters.
For example: "Ci.n". These parameters are in both the
Programming and Advanced Options menus.
To add or remove a parameter from the Programming
Menu, do the following:
1. Enter the Advanced Options Menu and select the
required parameter (See Section 2.6, steps 1
through 3).
2. With the required parameter displayed, press
keys.
NOTE: A period will be added or removed between the
2 nd and 3 rd characters of the selected parameter.
TO EXIT: Press
seconds without pressing a button or key.
7-7
T I N
May 2016
+
button to select the required
button to change parameter value.
+ keys or wait up to 30
+ keys or wait up to 30
keys
+