Hussmann Freedom Line series Installation & Operation Manual page 62

s
4-6
taRt
5. Clean the merchandiser as described in the
Care and Cleaning paragraphs of Section
5 – Maintenance. Keep liquid out of sockets.
(Allow merchandiser shelves to dry before
turning on shelf power.)
6. Verify that power is at the merchandiser
and turned on. Verify that the merchandis-
er light switch is turned "off." Switch is
located in the canopy, on the left, behind
first row of lamps.
7. See the illustration below. It is typical
of D5X, C5X, and D6X models. Note
that other models will have fewer rows of
shelves. Starting from the left-hand bottom
section, choose the location for the first
shelf, X-1.
Secure the shelf in the slotted upright.
Make certain that the shelf is level and
that ends are in the same slot on the left
and right upright. It is important that shelf
brackets be properly seated in the slotted
upright.
Shelf Socket
P/N 0527427_M
-U / o
p peRatIon
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900• www.hussmann.com
8. Working from left to right, install the next
shelf, X-2, to the right of the first shelf you
installed. Always work from left to right
and from the bottom up in each 8 ft (2438
mm) and 12 ft (3685 mm) merchandiser.
9. After each shelf on the bottom row is in
position, be sure to remove the cap and
insert the shelf connector. Push firmly.
10. Turn "ON" the merchandiser light switch
after the entire bottom row has been
installed in either 8 or 12 ft (2438 or 3658
mm) merchandisers. The shelf lights should
light.
If a shelf LED lights do not operate,
A. Turn off light switch.
B. Remove and firmly re-insert each shelf
plug.
C. Turn on light switch.
10 Sockets in
8-ft Case
Always work Left to Right,
and Bottom to Top
15 Sockets in
12-ft Case