P/N 0527427_M
Tighten End Frames
1. Begin at lower back to draw end frames
tight.
2. Tighten joints following the diagrams until
gaskets are compressed, and merchandisers
join smoothly.
3. Tighten screws in canopy (F) to complete
smooth fit.
4. Place plastic end caps over exposed threads.
NOTE: End caps must be placed over exposed
threads in food product areas to maintain NSF
compliance.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Seal Merchandisers
1. Remove wire shelf, interior front panel,
and interior panel support bracket to apply
butyl tape.
Shelf
Interior Front Panel
Interior Panel Support
End Cap
2. Apply butyl tape across the bottom joint.
Be sure to extend the tape up the back and
front of the merchandiser.
Silicone sealer may be applied around joining
bolts on both sides in bottom shoe but isn't
necessary if neoprene washers are used.
Bracket
Butyl Tape
Freedom Line Multi-Deck
1-13
Bring
butyl tape
up to this
point.