Hussmann Freedom Line series Installation & Operation Manual page 63

P/N 0527427_M
Note: LED lamps use a 24VDC power supply.
If a shelf fluorescent light does not operate:
A. Turn off light switch.
B. Make certain the shelf lamps are prop-
erly engaged in the shelf lamp holders.
C. Remove and firmly re-insert each shelf
plug.
D. Turn on light switch.
11. Using the row of shelves just installed as
support, set the next shelf, X-4, in the
desired location. Remove the cap and
insert the shelf plug. Continue working left
to right installing shelves X-5 and X-6.
Note: Since the location for the remaining
shelves, X-4 to X-15, may be directly over
the rear wall receptacle, the shelf should be
plugged in before engaging brackets in the
uprights. The lower shelf will support the
weight of the next shelf until it is plugged in.
After installing each shelf, verify that its plug
is properly connected to its rear wall recepta-
cle. Continue working row by row, bottom up,
left to right.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
INSTALLING FDA/NSF REQUIRED
THERMOMETER
The following pages provide the same
infor-mation that ships with the thermometer.
This requirement does not apply to display
refrigerators intended for bulk produce (refer to
page 1-1).
Please note that the tape cannot be exposed
after installation.
Freedom Line Multi-Deck
4-7