ABB ACF5000 Manual page 32

32
Signal lines
Analog outputs
Analog inputs
Digital outputs
Digital inputs
Data lines
Resistance thermometer
NOTICE
Assembly
ACF5000 FTIR ANALYZER SYSTEM
Shielded cables for the analog outputs (current outputs):
2 x 0.5 mm 2 or 2 x AWG20 per analog output
Shielded cables for the analog inputs (current inputs with the option
"external analog inputs"):
2 x 0.5 mm or 2 x AWG20 per analog input
2
Cables for the digital outputs:
5 x 0.5 mm 2 or 5 x AWG20 per group of 4 digital outputs
Cables for the digital inputs (with the option "external digital inputs"):
2 x 0.5 mm 2 or 2 x AWG20 per digital input
Cables for the data lines (Modbus, PROFIBUS, Ethernet), possibly fiber-optic
cables for longer transmission distances.
On the right side wall of the analyzer cabinet, connectors for the direct con-
nection of assembled data cables can be found (Sub-D 9-pin or RJ45 or M12
panel feed-through 5-pin or 8-pin).
Cables for the Pt 100 resistance thermometers in the heated components;
3 x 0.75 mm 2 or 3 x AWG20 per temperature sensor
When selecting the cable material, observe the applicable national safety
requirements for installing and operating electrical equipment.
Bolts and nuts for fastening the analyzer cabinet to the floor (see "Location
diagram in the system documentation)
| OI/ACF5000-EN REV. A