ABB ACF5000 Manual page 185

No. Text
512 Automatic adjustment in pro-
gress.
513 System bus communication
disrupted during automatic
adjustment.
514 External adjustment started.
515 External adjustment ended.
516 External adjustment in pro-
gress.
517 Device is being serviced.
518 The adjustment could not be
carried out, because the meas-
ured value is instable.
519 Pre-amplifier overrun error: The
adjustment could not be car-
ried out, because the
pre-amplifier is overdriven.
520 Basic adjustment zero point
started.
521 Basic adjustment zero point
ended.
522 Basic adjustment zero point
canceled.
523 Basic adjustment zero point
incomplete. System bus com-
munication disrupted during
adjustment.
524 Basic adjustment zero point in
progress.
525 Linearization not possible: The
linearization provides no valid
result. Measured value may be
imprecise. Check center point
gas.
526 Linearization not possible: The
linearization could not be car-
ried out, as the identification
line is not linear.
527 Basic adjustment for compo-
nent:
528 Automatic adjustment could
not be started, as the adjust-
ment was manual.
529 The adjustment was canceled,
as no raw measured values can
be entered.
530 The adjustment was canceled,
as the pressure switch did not
detect adjustment gas.
531 Auto validation started.
532 Auto validation ended.
ACF5000 FTIR ANALYZER SYSTEM
S A W F Reaction/Comment
x for information; not in the logbook
for information
for information
x for information; not in the logbook
x for information, e.g. during a manual adjustment; not in
the logbook
for information
for information
for information
for information
x for information; not in the logbook
see message text
see message text
for information
for information
x x
x x
for information
for information
| OI/ACF5000-EN REV. A 185