ABB ACF5000 Manual page 181

No. Text
214 The system is currently being
maintained with Optima SMT.
215 The analyzer module has an
internal communication error!
216 The analyzer module has an
internal program error!
250 The analyzer module could not
be found.
251 The connection to the analyzer
module was lost.
252 The EEPROM data of the ana-
lyzer are faulty.
253 The communication with the
analyzer is disrupted,
254 The boot program of the ana-
lyzer module is faulty. Notify
Service!
255 The program of the analyzer
module is faulty. Notify Service!
Analyzer modules
300 No new measured values from
the analog/digital converter.
301 The measured value exceeds
the value range of the ana-
log/digital converter.
302 The offset drift exceeds the
half of the range permissible.
303 The offset drift exceeds the
permissible range.
304 The amplification drift exceeds
the half of the range permissi-
ble.
305 The amplification drift exceeds
the permissible range.
306 The offset drift between two
adjustments exceeds the per-
missible range.
307 The amplification drift between
two adjustments exceeds the
permissible range.
308 A calculation error occurred
while calculating the measured
value.
309 The thermostat works errone-
ously.
310 The temperature correction for
this component was deac-
tivated because the tempera-
ture measured value is invalid.
ACF5000 FTIR ANALYZER SYSTEM
S A W F Reaction/Comment
x x Notify service.
x x Notify service.
x x Check plug connection and wiring.
x x Check plug connection and wiring.
x x Check configuration with TCT.
x x Check plug connection and wiring.
x x Notify service.
x x Notify service.
x x Notify service.
x x Check measuring gas concentration. Notify service.
x Check analyzer module and sample preparation. Permis-
sible range: 150% of the smallest measuring range in-
stalled. As soon as the drift exceeds these values, notify
x x
service.
x Adjust detector displayed manually at the zero point and
end point. Check analyzer module and sample prepara-
tion. Permissible range: 50% of the sensitivity of the
detector. As soon as the drift exceeds this value, notify
x x
service.
x These messages are created by the automatic adjust-
ment. Check plausibility of the adjustment. Rectify pos-
sible cause of an implausibility. Adjust detector dis-
played manually at the zero point (no. 306) or at the end
x
point (no. 307). Permissible range: 15% of the smallest
measuring range installed; 6% of the smallest measuring
range for measurements on plants and systems requir-
ing approval of 27 and 30 BImSchV
x x Notify service.
x see status message of the relevant temperature
x see status message of the relevant temperature
| OI/ACF5000-EN REV. A 181