Table of Contents
Advertisement
1
PRODUCT DESCRIPTION AND INTENDED USE
This product is a tubular motor for automating indoors roll-up awnings, or indoors
sunscreens, or similar roll-up equipment (fig. 1). Do not use it for any other pur-
pose! The manufacturer declines all liability for damage resulting from im-
proper use of the product or any other use than that specified in this manual.
The product has the following functional characteristics:
• it can be powered using an MLPS12006 12 V DC battery pack manufactured by
Nice S.p.A.;
• it has two separate cables: one power cable and one control cable;
• it installs inside the winding roller; the part of the motor that protrudes from the roller
(electronic head) mounts to the ceiling or wall with brackets (not included);
• it has a built-in radio receiver and control unit with encoder technology that elec-
tronically controls the movement and precision of the limit switches;
• it is compatible with all Nice control electronics using the NRC radio system (climate
sensors and transmitters);
• it can be programmed with a compatible radio transmitter ("ERA P" / "ERA W" se-
ries). These have two keys on their backs which serve only for programming, and
which are protected by a cover to prevent accidental reprogramming.
The programming can also be done with a dedicated programming unit (TTP, etc.).
These accessories (including portable radio transmitters) are not included;
• it can be controlled with a radio transmitter (see fig. 2). These accessories are not
included;
• it can move the awning up or down; stop it at the upper limit switch, the lower limit
switch or various intermediate positions;
• it moves awnings of different weights at the same speed;
• the up and down speeds are the same;
• it allows you to set the nominal awning speed, so that the user can select three
commands: "fast", "nominal" and "silent-soft";
• it enables you to adjust the movement's duration;
• it enables you to set the acceleration and deceleration at the start/end of the move-
ment respectively;
• it features a security system that detects the presence of an obstacle along the
awning travel, immediately blocking the movement in progress and performing a
brief inversion of movement. The same system is automatically activated at the end
of the Up movement (only if the upper limit switch "0" consists of a box or other me-
chanical stop), to mitigate the impact of the awning against the housing and loosen
the tension exerted by the motor on the canvas, when the awning is stationary at
the upper limit switch "0".
• it enables you to customise the radio transmitter commands (Mode II).
• it enables you to precisely adjust the limit switches with the buttons on the mo-
tor head;
• it has an integral led which indicates the system status and any malfunctions;
• it is equipped with a thermal protection system which, in the case of overheating
caused by overuse of the automated mechanism (beyond the indicated limits, see
the Technical Specifications chapter), automatically cuts off the electricity supply,
restoring it as soon as the temperature goes back to normal.
1
With box
(the Up limit position
is given by the awning
touching the box).
Without box
(the Up limit position
is programmed by the
installer).
English – 2
Advertisement
Table of Contents
