Table of Contents
Advertisement
GENERAL INFORMATION ABOUT PROCEDURES "A.12", "A.13", "A.14"
The "Cruise speed" (procedure A.12), "Acceleration/deceleration of the movement" (procedure A.13) and "Movement dura-
tion " (procedure A.14) functions allow you to completely customise the movement of the awning, allowing you to align mul-
tiple awnings of different sizes, with different diameter rollers (among other effects), or make the awning run more quietly.
• The "Movement duration (procedure A.14)" and "Cruise speed (procedure A.12)" functions are interdependent: the last
function to be set determines the awning's actual cruise speed.
• After setting the movement time (procedure A.14), the system automatically adjusts the cruise speed (while accounting
for the acceleration/deceleration values) to ensure that the movement lasts exactly the set time.
If you then change theacceleration/deceleration settings (procedure A.13), or the limit positions (procedure A.3 / A.4),
the movement duration remains unchanged and the system adjusts the cruise speed accordingly.
• When setting the movement duration (procedure A.14), if the resulting cruise speed is outside the allowed range (see
the values given in "Technical specifications"), the motor reports the error by moving 6 times at the end of the procedures
(A.3 / A.4 / A.13), and automatically restores the cruise speed to its nominal value.
• After you have set the cruise speed with procedure A.14, changing the limit positions (procedure A.3 / A.4) or accel-
eration/deceleration settings (procedure A.13) may set the cruise speed outside the allowed range (given in "Technical
specifications"). If so, the motor will move 6 times to report the error at the end of the procedures (A.3 / A.4 / A.13), and
will automatically restore the nominal cruise speed.
A.12 - Adjusting the awning's cruise speed
A
NOTES AND WARNINGS
• For the values of the three options (minimum, nominal and maximum speed), see "Technical characteristics".
• Todetermine whether the option chosen for the cruise speed of the awning is compatible with the characteristics of the your awning (weight, roller dimensions, torque),
refer to "Technical characteristics".
• The "nominal speed" setting is the factory setting.
1
(x 1)
PRG
Press and release
count 2 movements.
the button (1 time);
4
Select the desired op-
tion and program it as
follows
4
1 /
2 /
7
3 /
sec.
After about 7 seconds, the motor performs a num-
ber of movements equal to the number of pulses
entered.
15 – English
2
(x 1)
2
PRG
Press and release
the button (1 time);
(x ...)
3 OPTIONS:
1 press = sets MINIMUM speed
2 presses = sets NOMINAL speed
3 presses = sets MAXIMUM speed.
Press and release the button the number of times indicated in the option you have chosen;
5
= 5 sec
?
Hold down the buttonand
3
= 5 sec
2
count 2 movements.
Hold down the but-
tonand
release it after 5 seconds;
3
release it after 5
count 3 movements.
seconds;
continues
end
3
count 3 movements.
4
Advertisement
Table of Contents
