Table of Contents
Advertisement
A.5 - Programming an INTERMEDIATE POSITION (position "H")
A
NOTES AND WARNINGS
• This procedure memorises an intermediate position (position "H") between the Up ("0") and Down ("1") limit switch positions. When the automation is being used,
after giving the intermediate position command, the system will automatically stop the awning at the programmed "H" position.
• You can memorise up to 30 "H" positions wherever you wish, provided that these are between the two limit switch positions. These positions can only be pro-
grammed after the limit switch positions. Repeat this procedure for each position you wish to memorise.
• The first "H" position must be programmed using the buttons s+t, on the transmitter used to run the procedure itself. However, each subsequent position
"H" must be programmed using a button on another non-memorised transmitter.
• To change an existing "H" position, move the awning to the desired height and run this procedure; in step 06, however, press the button associated with the exist-
ing "H" position you are changing.
1
2
(x 1)
" H "
Move the awning to the
Press and release
desired "H" position.
the button (1 time);
4
Precisely ad-
justing the
"H" posi-
tion
Press the buttons until you reach the desired position.
Alternatively, for more accurate adjustment, run pro-
cedure B.1.
6
= 5 sec
Hold down both but-
release them after
tons...
5 seconds;
A.6 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
A
NOTES AND WARNINGS
• To run procedures A.6.1.A and A.6.2.A, you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must
have the "PRG" and "ESC" buttons (like "ERA P" and "ERA W" transmitters).
• To run procedures A.6.1.B and A.6.2.B you must have a new transmitter to memorise, chosen from the "Nice Screen" catalogue , and an old previously memorised
transmitter.
A.6.1 - To memorise the transmitter buttons in "Mode I" ("Standard mode")
• Procedures A.6.1A and A.6.1.B memorise all the new transmitter's buttons in "Mode I", with the same configuration as the old transmitter (for details about "Mode
I" see par. 4.4.1-A).
A.6.1.A - Procedure for transmitters equipped with the "PRG" and "ESC" buttons ("ERA P" and "ERA W")
1
PRG
OLD
On the OLD transmitter: hold down the
button and
2
PRG
count 2 movements.
5
= 5 sec
" H "
Hold down the but-
ton and
end
4
count 4 movements.
2
...
sec
wait ...
count 2 movements;
3
= 5 sec
release them after 5 seconds;
Hold down both buttons...
release it after 5 sec-
count 3 movements.
onds;
6
= 5 sec
...
On ANOTHER transmitter,
which has NOT been memo-
rised: hold down any button
you wish;
2
1
sec
wait again...
count 2 more move-
ments;
4
2
count 2 movements.
6
...
Select one of the following potions
and execute it:
• option A – to memorise the
3
FIRST "H" position.
• option B – to memorise a SUP-
PLEMENTARY "H" position.
...
4
release it after
count 4 movements.
5 seconds;
2
PRG
release the button.
end
English – 10
Advertisement
Table of Contents
