Table of Contents
Advertisement
A.10 - Programming the motor's sensitivity to obstacles
A
NOTES AND WARNINGS
• Use this procedure to activate or deactivate the safety system that: a) detects the presence of an obstacle along the travel of the awning; b) reduces the motor ten-
sion on the awning when it is stationary at the Upper limit switch "0" (only if there is a box or other mechanical stop at this limit switch).
• This procedure adjusts the limit of the traction force that the motor can exert on the awning in an attempt to release it, when it is stopped suddenly by an obstacle
or friction. At the same time, if the Upper limit switch "0" is the box or other mechanical stop, the system uses the same value set with this procedure, to reduce the
impact of the awning against the box and loosen the tension exerted by the motor on the canvas, when the awning is stationary at the Upper limit switch "0".
• The following options are available:
– sensitivity to obstacles: ENABLED – this setting is only active when the awning is moving Up. The motor delivers a lot of force and will often be able to unjam
the awning, even when the load is varying due to friction or small obstacles.
– sensitivity to obstacles: DISABLED – this setting disables the safety system (factory setting).
1
(x 1)
2
PRG
Press and release
count 2 movements.
the button (1 time);
4
(x ...)
Select the de-
sired option and
program it as fol-
lows
Press and release the button the number of times indicated in the option you have chosen;
4
n
7
sec.
After about 7 seconds, the motor performs a num-
ber of movements equal to the number of pulses
entered.
2
(x 1)
PRG
Press and release
count 2 movements.
the button (1 time);
2 OPTIONS:
1 press = ENABLED function
5 presses = DISABLED function
5
= 5 sec
?
Hold down the button and
3
= 5 sec
2
Hold down both buttons...
continues
release it after 5
count 3 movements.
seconds;
release them after 5
count 2 movements.
seconds;
end
3
4
2
English – 14
Advertisement
Table of Contents
