Table of Contents
Advertisement
A.6.2.B - Procedure for transmitters without the "PRG" and "ESC" buttons"
• When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
= 8 sec
NEW
On the NEW transmitter: hold down the but-
ton you want to memorise;
3
Select the desired
option and program
it as follows
OLD
On the OLD transmitter: press and release the button the number of times indicated in the option you have chosen;
3
n
?
7
sec.
After about 7 seconds, the motor performs a
number of movements equal to the number of
pulses entered.
A.7 - Memorisation of a climate sensor connected via radio
A
NOTES AND WARNINGS
• To run this procedure you need the climate sensor you want to memorise, chosen from the "Nice Screen" catalogue, and an old transmitter memorised in Mode I
(see par. 4.4.1-A).
• When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
= 10 sec
P1
sensor
On the climate SENSOR: hold down
the yellow button "P1";
A.8 - TOTAL or PARTIAL deletion of memory
A
NOTES AND WARNINGS
• In order to carry out the following deletion procedures, the transmitter must be memorised in mode I.
A.8.1 - Procedure run with a memorised transmitter
1
(x 1)
2
PRG
Press and release
count 2 movements.
the button (1 time);
...
...
release it after 8 sec-
onds;
8 OPTIONS:
1 press = Open > Stop > Close > Stop > ...
(x ...)
2 presses = Open
3 presses = Close
4 presses = Stop
5 presses = Open after 10 seconds
6 presses = Open after 20 seconds
7 presses = Close after 10 seconds
8 presses = Close after 20 seconds
4
NEW
On the NEW transmitter: hold down the
same button you pressed in Step 1;
2
P1
OLD
release it after 10
On the OLD transmitter: press
seconds;
and release (3 times) any button.
2
(x 1)
PRG
Press and release
count 2 movements.
the button (1 time);
2
= 5 sec
OLD
On the OLD transmitter: hold down the
button and
= 5 sec
...
...
release it after 5
seconds;
3
(x 3)
...
sensor
On the climate sensor: press and
release (1 time) the yellow button
"P1";
3
(x 1)
2
PRG
Press and release
the button (1 time);
release it after 5
count 4 movements.
seconds;
continues
3
count 3 movements (= transmitter memo-
rised). If the system makes 6 movements (= mem-
ory locked or full, transmitter not memorised).
(x 1)
3
P1
count 3 movements (= sen-
sor memorised). If the sys-
tem makes 6 movements (=
memory locked or full, sensor
not memorised).
4
3
count 3 movements.
3
4
end
end
English – 12
English – 12
Advertisement
Table of Contents
