Run Procedure - Nice E EDGE XSI 0620 LDC Instructions And Warnings For Installation And Use

4
(x 1)
PRG
Press and release count 4 movements.
the button (1 time);
5
(x 1)
PRG
Press and release the count 5 movements.
button (1 time);
5
= 5 sec
Hold down the but- release it after 5
tonand seconds;
5
= 5 sec
Hold down both buttons...
A.8.2 - Procedure run with a transmitter which has not yet been memorised
NOTES AND WARNINGS
• In order to carry out the following procedures, a transmitter with a PRG button should be used.
A.8.2.A - Procedure run with a transmitter which has not yet been memorised and cables for the voltage free contacts
1
OFF
Disconnect the electrical Connect the white and white-black
power supply to the motor. wires together.
A.8.2.B - Procedure run with a transmitter that has not yet been memorised and the limit switch adjustment buttons on the motor head
1
= 5 sec
On the motor head: hold down both
buttons and
13 – English
...
5
Select one of the following potions and execute it:
• option A – delete the motor's ENTIRE memory.
• option B – delete ALL memorised transmitters.
4
• option C – delete ONE memorised transmitter.
• option D – delete ALL positions ("0", "1", "H", etc.). Caution! – This deletion must be performed only when you want to
reprogram all the positions, using a different procedure than the one used previously (e.g. you have used manual distance
programming (A.3) and would now like to use the semi-automatic procedure (A.4).
end
5
3
count 3 movements.
release them after 5 count 5 movements.
seconds;
2
release them after 5 seconds;
5
= 5 sec
Hold down the buttonand release it after 5 seconds;
6
= 5 sec
On the transmitter you wish to delete: hold down
any button either the key memorised in mode 2 or the
climatic conditions sensor;
end
5
3 4
ON

Run procedure

A.8.1 in full.
Reconnect the electrical pow-
er supply to the motor once
again.
the red led starts flashing (it turns off when the procedure is
completed).
5
count 5 movements.
5
count 5 movements.
...
when the light starts
flashing, you have 1
minutes to complete
the procedure.
end
end
2 ...
Run procedure
A.8.1 in full.