Advertisement
1
PRODUCT DESCRIPTION AND
INTENDED USE
This product is a tubular motor for automating indoors roll-up awnings, or indoors
sunscreens, or similar roll-up equipment (fig. 1). Do not use it for any other pur-
pose! The manufacturer declines all liability for damage resulting from im-
proper use of the product or any other use than that specified in this manual.
The product has the following functional characteristics:
• it is powered by a rechargeable battery (consult the motor's nameplate ratings);
• it installs inside the winding roller; the part of the motor that protrudes from the roller
(electronic head) mounts to the ceiling or wall with brackets (not included);
• it has a built-in radio receiver and control unit with encoder technology that elec-
tronically controls the movement and precision of the limit switches;
• it is compatible with all Nice control electronics using the NRC radio system (climate
sensors and transmitters);
• it can be programmed with a compatible radio transmitter ("ERA P" / "ERA W" se-
ries). These have two keys on their backs which serve only for programming, and
which are protected by a cover to prevent accidental reprogramming;
• it can be controlled with a radio transmitter (see fig. 2). These accessories are not
included;
• it can move the awning up or down; stop it at the upper limit switch, the lower limit
switch or various intermediate positions;
• it moves awnings of different weights at the same speed;
• the up and down speeds are the same;
• it allows you to set the nominal awning speed, so that the user can select five com-
mands;
• it enables you to adjust the movement's duration;
• it enables you to set the acceleration and deceleration at the start/end of the move-
ment respectively;
• it features a security system that detects the presence of an obstacle along the
awning travel, immediately blocking the movement in progress and performing a
brief inversion of movement;
• it enables you to customise the radio transmitter commands (Mode II);
• it has an integral led which indicates the system status and any malfunctions;
• it is equipped with a thermal protection system which, in the case of overheating
caused by overuse of the automated mechanism (beyond the indicated limits, see
the Technical Specifications chapter), automatically cuts off the electricity supply,
restoring it as soon as the temperature goes back to normal.
1
With box
(the Up limit position
is given by the awning
touching the box).
Without box
(the Up limit position
is programmed by the
installer).
English – 2
Advertisement
